02/04/2014
Marine Engineer Officer Class-5
Exam (Syllabus) :
Subject-1: Naval Architecture
General displacement, wetted
surface, block, mid section,
prismatic and water plane area
coefficient, ton per centimeter
immersion. Apply of Simpson’s
rule in case of area, volume and
moment of volume.
Draught and buoyancy, Change
in average draught for changing
density of water. Buoyancy and
reserve buoyancy. Result of
bilging in mid-ship
compartments.
Transverse stability- center of
gravity, center of buoyancy, meta
center, change in center of
gravity for adding and reducing
mass, stability at small angle of
heal, inclining experiment
Ship construction- General
measurement term used in steel
build ship, e. g. length between
perpendiculars, breadth overall,
moulded depth, draught and
free board. Definition of general
used ship building terms. Water
tight door & hatches.
Tank and others- fore and aft
peak tanks, double bottom and
deep tank filling and pumping
arrangements
Load line- primary knowledge of
load line.
Subject-2: Machine Drawing
Drawing question paper will be
made to test the ability to use
projection rules. It will be asked
to student to draw plan,
elevation or section view (or all
of these view together) of a
marine machinery. To complete
drawing all kind of necessary
information will be provided in
question paper.
Following terms could be used
as drawing guideline——
Air Inlet Valve
Automatic Valve
Bilge Suction Strainer
Compressor Piston and Suction
Valve
Control Valve
Cylinder Relief Valve
Feed Check Valve
Flow Regulator
Fuel Valve
Fuel Control Lever
Gear Pump
Hydraulic Steering Gear
Oil Strainer
Piston Four Stroke
Piston Upper and Rod
Quick Closing Valve
Reducing Valve
Rudder Carrier Bearing
Starting Air Valve
Starting Air Pilot Valve
Universal Coupling
Subject-3: Coastal Vessel
Engineering Knowledge (General)
Ability to supply information of
small parts of machinery with
sketches, notes, specifications
and dimensions.
Constructing system of various
equipment and properties of
generally used elements.
Basic knowledge on
constructional details of steering
system and it’s working
procedure.
(a)Working principles of pumps;
(b) general requirement for
pumping system
Working principles and
construction details of oily water
separator
(a)Maintenance & operation of
fire extinguishing equipment.
(b)Detection & prevention of fire.
Refrigeration: Basic principles of
refrigeration; use and properties
of refrigerant
Basic Knowledge of Boilers
Subject-4: Coastal Vessel
Engineering Knowledge (Motor)
Working procedure of Marine
Diesel Engine, Gear, Clutch and
Auxiliary Machinery.
Concept of fuel oil, lubrication
oil, diesel engine cooling system,
filter, pump hear exchanger and
control system.
Maneuvering systems, bridge
control system, variable pitch
propeller.
Emergency controls.
Working procedure of air
compressor, air receiver and
related equipment.
Operation and testing of general
automatic control system and
alarm panel.
Basic concept of fuel injection,
fuel pump and injector.
Scavenging and supercharging;
scavenging procedure of two
stroke and four stroke engine;
exhaust system; general rules of
turbo charger.
Air starting system; general rule
of engine cooling (fresh water
and sea water)
Hazards of engine operation,
crankcase explosion
Safe and effective operation and
maintenance of marine diesel
engine.
Source: Bangladesh gadget,
extra, February 13, 2011; page
no. 1869-1872
